Removing Sediment in Your Sacramento Water Heater

Posted by on Dec 13, 2013 in Water Heater Repair Sacramento

If you have a trouble with sediment, you’re most likely currently familiar with it. Gas fired water heaters in certain often show that there is a sediment issue with rumbling sounds each time the tank cycles, while still keeping good water temperature level. Fortunately, sediment in your hot water tank can easily be flushed out, preserving the functionality of your heater.

Water Heater Repair Sacramento

Water heater (Photo credit: km6xo)

If you have a gas water heater, turn the control to pilot. If you have an electric model, you must switch off the electrical power at the panel. Next turned off the water above the heater so no new water can get in the tank. Then connect a hose to the drain valve. The various other end of the hose should ideally go to a floor drain, although a pail can also be utilized.

Open the drain valve to get rid of all the water from the tank. Many of the sediment needs to be removed by this simple act. Keep the drain valve open, however turn on the water too, permitting some to enter the tank. Turn off the water after a couple of minutes. Repeat this a number of times to coax as much sediment out with the water.

As a last procedure, close the drain and fill the tank at least half way. Then you can drain it for a last time to get rid of any last bits of sediment. To avoid further usual sediment issues, you can set up a sediment filter for your tank if your problem is mostly with sand. A sand filter need to be installed on the cold trunk line.

Often sediment can likewise clog up the drain valve itself. Preferably you should be able to rinse the valve out under high pressure, but sometimes the valve has to be replaced after a cleaning. You can achieve this job while the tank is still complete, simply switch off the gas or electricity and wait for the water in the tank to cool. You must also not utilize any water in your residence will completing the replacement.

To get rid of the drain valve, merely utilize a large groove joint pair of pliers to turn off the old valve. Then set up a replacement valve by turning it in clockwise. Make sure to make use of pipe thread sealing tape or pipe joint substance on the threads to ensure that the connection will hold water.

If you are planning to eliminate the drain valve, you might think about prior to setting up the replacement valve providing your tank a last flush. This is finest done if you have a floor drain that will rapidly drain the water and sediment.

Many individuals incorrectly think that a sediment filled tank or a leaky drain valve is cause to replace the entire hot water heater. By these easy maintenance actions, the majority of homeowners need to have the ability to take care of any problems on their own. Naturally, if you experience various other problems while finishing this repair, call a plumber who will have the ability to quickly resolve the issue.

Water Heater Repair Sacramento invites you to read more from us:

 Sacramento Gas Water Heater Troubleshooting Advice

How Much Energy Does a Tankless Water Heater Save

What AFUE Is

Enhanced by Zemanta