Sacramento 10 Minute Water Heater Maintenance Check

Posted by on Feb 26, 2014 in Water Heater Repair Sacramento

We are going to put you to work today, but just for about 10 minutes. Yep, that’s all it will consider these 2 vital water heater upkeep tasks; however, Water Heater Repair Sacramento knows they will do an exceptional task of helping with three things:

  1. Having your water heater last as long as possible (that will conserve you cash).
  2. Seeing to it the water heater runs securely (we do not desire it to blow up).
  3. Having it run as energy efficiently as possible (also saving you money).

So with that in mind, are you prepared to invest 10 minutes once or two times a year to assist conserve some cash? Water Heater Repair Sacramento CA thought so.

Testing the T&P Relief Valve

Typically called the T&P Valve, or the temperature and pressure relief valve, has a crucial task. It helps make certain excess pressure does not build up inside the water storage tank, or in even more basic terms, it makes sure the water heater does not explode. As the photo shows, it has a lever or little handle on it. All you have to do is raise it part way and then release it. Hopefully, it snapped back to its closed position quickly. If it is working correctly, a little water can be heard entering into the drain pipe below the lever you just lifted and you maybe heard some pressure being released. If none of these things have occurred throughout the test, the valve will require to be changed.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Perform a Mimi Water Heater Tank Flush

By nature, rust and deterioration will take place inside the water tank thanks to the chemical reactions taking place with all the components inside that are required to heat up the water. We will not get overly technical right here, but it is easy to help prevent this process by doing a flush or draining of all or some of the water in the tank.

For just a tiny flush, put a pail under the drain valve below the tank. Open the drain valve and fill the bucket with water. Drain at least a couple of gallons of water in total. Let the water sit in the pail for a couple of minutes to settle and examine if there is much that settles to the bottom of the container. If there is, if the water heater has actually not been drained for a very long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will desire to turn the temperature dial down and could wish to let the water cool down for about an hour first so it is not too hot while draining it. Also, it would be easier to connect a hose to the drain valve and let the water go outside rather of utilizing pails.

If the water looks fairly clean and clear from the tiny test you should be all set. When the water heater has an excessive amount of sediment inside of it, it can make loud popping sounds and it minimizes its efficiency too.

Though water heaters are fairly upkeep free and not difficult to operate, any time you feel the smallest awkward or are not sure of what to do, it is always best to have a plumbing expert assist with the circumstance.

Water Heater Repair Sacramento